1. PRODUCT IDENTIFICATION
1. PRODUCT IDENTIFICATION
| Product Name : | Oberon F202 |
| UN Proper Shipping Name : | None allocated |
| Other Names : | None listed |
| Product Use : | Water displacing fluid, rust preventative, lubricant. |
| CHEMTREC, 24-HOUR EMERGENCY TELEPHONE NUMBER | |
| 1-800-424-9300 (Toll-free) | For United States and Canada |
| 1-703-527-3887 | In the event of an incident occurring outside United States and Canada |
2. HAZARDS INDENTIFICATION
| NOHSC Classification | Classified as hazardous according to criteria of NOHSC. |
| Dangerous Goods Classification |
Not classified as a Dangerous Goods
according to the Code for the Transport of Dangerous Goods by Road and
Rail. Note: Combustible materials may be classified as Class 9: miscellaneous dangerous goods if transported with flammable materials. |
| SUSDP Classification | S5 |
| Risk Phrases |
R65 Harmful: may cause lung damage if
swallowed. R66 Repeated exposure may cause skin dryness or cracking. |
| Safety Phrases |
S23 Do not breathe gas/fumes/vapour/spray. S24 Avoid contact with skin. S33 Take precautionary measures against static discharges. S62 If swallowed, do not induce vomiting; seek medical advice immediately and show this container or label. |
3. COMPOSITION/INFORMATION ON INGREDIENTS
| NAME | CAS NUMBER | PROPORTION | RISK PHRASES |
| Highly refined paraffinic mineral oil | 64742-65-0 | 30 to 60% | - |
| Naphtha (petroleum), hydrotreated heavy | 64742-48-9 | 30 to 60% | R65, R66 |
| Other ingredients determined not to be hazardous | Not Required | < 10% | - |
4. FIRST AID MEASURES
| Swallowed | DO NOT induce vomiting. Immediately wash out mouth with water, and then give plenty of water to drink. Seek medical attention. |
| Eye | Rinse eyes immediately with water for at least 15 minutes. In case of irritation, seek medical advice. |
| Skin | Remove all contaminated clothing. Wash gently and thoroughly with water and non-abrasive soap. Ensure contaminated clothing is washed before re-use or discard. If irritation develops and persists, seek medical attention. |
| Inhaled | Remove the patient to fresh air. Ensure airways are clear and have qualified person give oxygen through a facemask if breathing is difficult. If irritation develops, seek medical attention. |
| First Aid Facilities | No special facilities required. |
| Advice to Doctor | Treat symptomatically |
5. FIRE FIGHTING MEASURES
| Fire/Explosion Hazard | Combustible liquid, C1. Avoid sources of ignition, heat and nake flames. |
| Extinguishing Media | Use water as fog or spray to cool fire exposed containers. Do not use direct stream of water; product will float, possibly re-igniting. |
| Fire Fighting | Self-Contained Breathing Apparatus (SCBA) and full protective clothing should be worn. |
| Flash Point | > 67 oC (PMCC) |
| Hazchem Code | None allocated. |
| Hazards from Combustion Products | Oxides of carbon. |
6. ACCIDENTAL RELEASE MEASURES
| Spills Procedure |
SMALL – 20 LITRES OR LESS Soak up with inert oil absorbent. Arrange for disposal through an approved facility. LARGE – GREATER THAN 20 LITRES Remove all sources of ignition. Increase ventilation. Evacuate all unnecessary personnel. Wear full protective equipment and clothing to minimise exposure. If possible contain the spill. Place inert absorbent material such as vermiculite, sand or dirt onto spillage. Use clean non-sparking tools to collect the materials and place into a suitable labelled container. If large quantities of this material enter the waterways contact the Environmental Protection Authority or your local Waste Management Authority. |
7. HANDLING AND STORAGE
| Handling |
Repeated or prolonged contact with this
material should be avoided in order to lessen the possibility of skin
disorders. It is essential that all who come into contact, maintain high
standards of personal hygiene ie. Washing hands prior to eating,
drinking or going to the toilet. Build-up of mists in the working
atmosphere must be prevented. Misuse of empty containers can be hazardous. Do not cut, weld, heat or drill containers. Residue may ignite with explosive violence if heated sufficiently. Do not pressurise or expose to open flame or heat. Keep container closed and bung in place. |
| Storage Precautions | Keep container closed. Handle containers with care. Open slowly in order to control possible pressure release. Store in a cool well-ventilated place away from incompatible materials. Do not handle, store or open near an open flame, sources of heat or sources of ignition. Protect material from direct sunlight. Material will accumulated static charges which may cause an electrical spark (ignition source). Use proper grounding procedures. Do NOT pressurise, cut, heat or weld containers. Empty product containers may contain product residue. Do NOT reuse empty containers without commercial cleaning or reconditioning. For information on the design of the store-room for storage and handling of flammable and combustible liquids, reference should be made to any relevant Commonwealth, State or Territory regulations. |
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
| Exposure Limits |
No value assigned for this specific
material by the National Occupational Health and Safety Commission (NOHSC).
However, Exposure Standards for constituents/hazardous decomposition
products are listed below SUBSTANCE TWA STEL
ppm mg/m3 ppm mg/m3 Oil mist, mineral - 5 - 10 Naphtha (petroleum), hydrotreated heavy 100 - - - Exposure Standard means the average concentration of a particular substance in the worker’s breathing zone, exposure to which, according to current knowledge, should not cause adverse health effects nor cause undue discomfort to nearly all workers. It can be of three forms; time-weighted average (TWA), peak limitation, or short-term exposure limit (STEL). |
| Biological Limit Values | No biological limit allocated. |
| Engineering Control | The use of mechanical dilution ventilation is recommended whenever this product is used in a confined space, is heated above ambient temperatures or otherwise to maintain ambient concentration below the recommended threshold exposure limits. |
| Respirator Type | Avoid breathing vapours or mists. Select and use respirators in accordance with AS/NZS 1715/1716. When vapours are generated, the used of the following is recommended: Half face piece respirator with dust/mist filters. The appropriate filter capacity and respirator type will depend on exposure levels encountered. |
| Eye Protection | Chemical safety goggles are recommended. If handled hot, a full face shield should be worn. |
| Glove Type | Use of impervious rubber gloves is recommended. |
| Clothing | Clothing should be suitable to avoid product contacting the skin on a prolonged or repeated basis. |
9. PHYSICAL AND CHEMICAL PROPERTIES:
| Appearance | Light green oily liquid |
| Odour | Methyl salicylate |
| Melting Point (oC) | Not available |
| Boiling Point (oC) | Not available |
| Vapour Pressure | Not available |
| Vapour Density | Not available |
| pH | Not applicable |
| Specific Gravity | Approximately 0.84 g/m3 |
| Flashpoint (oC) | > 67 oC (PMCC) |
| Flamm. Limit LEL | Not available |
| Flamm. Limit UEL | Not available |
| Solubility in Water | < 0.1 g/l |
10. STABILITY AND REACTIVITY
| Stability | Stable under normal conditions of storage and handling. |
| Conditions to Avoid | Do not handle, store or open near an open flame, sources of heat or sources of ignition. Protect material from direct sunlight. Material will accumulate static charges which may cause an electrical spark (ignition source). Use proper grounding procedures. Do NOT pressurise, cut, heat or weld containers. |
| Incompatible Materials | Strong oxidising agents. |
| Hazardous Decomposition Products | Oxides of carbon. |
| Hazardous Reactions | No hazardous polymerisation will occur. |
11. TOXICOLOGICAL INFOMATION
| Toxicology | The classification as a carcinogen need not apply in this case as the main constituents in this product are in accordance with Note L of the NOHSC Designated List of Hazardous Substances (containing less than 3% DMSO extract as measured by IP 346). |
| Acute - Swallowed | May cause lung damage if swallowed. May cause irritation to the mouth, oesophagus and stomach. Symptoms can include nausea, vomiting and diarrhea. May cause central nervous system depression. Ingestion and subsequent vomiting of this product can lead to aspiration of the solvent into the lungs, which can result in a type of chemical pneumonia. |
| Acute - Eye | May cause irritation in contact with the eyes, which can result in redness, stinging and lachrymation. |
| Acute - Skin | Prolonged or frequent contact may cause skin irritation or cracking to sensitive skins. |
| Acute - Inhaled: | Vapour concentrations above recommended exposure levels may be irritating to the eyes and the respiratory tract, may cause headaches and dizziness, could be anaesthetic and may have other central nervous system effects. |
| Chronic | Prolonged or repeated contact may cause redness and burning of the eyes and skin. Persons with pre-existing skin and lung disorders may be more susceptible to the effects of this product. Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling this product may be harmful or fatal. May cause defatting, oil acne or allergic reactions in sensitive individuals. |
12. ECOLOGICAL INFOMATION
| Ecotoxicity | No ecotoxicological classifications. |
| Persistence and Degradability | This substance is readily biodegradable according to OECD guidelines. This substance can degrade rapidly in air and is expected to be removable in a wastewater treatment facility. |
| Mobility | This substance will rapidly evaporate to the air if released into the water. |
13. DISPOSAL CONSIDERATION
| Disposal Method | Dispose of waste according to federal, EPA, state and local regulations. Assure conformity with all applicable regulations. |
| Special Disposal Precautions | Do not handle, store or open near an open flame, sources of heat or sources of ignition. Protect material from direct sunlight. Material will accumulate static charges which may cause an electrical spark (ignition sources). Use proper grounding procedures. Do NOT pressurise, cut, heat or weld containers. |
14. TRANSPORT INFORMATION:
| UN Number | None allocated |
| UN Proper Shipping Name | None allocated |
| DG Class |
Not classified as a Dangerous Good
according to the Code for the Transport of Dangerous Goods by Road and
Rail. Note: Combustible materials may be classified as Class 9: miscellaneous dangerous goods if transported with flammable materials. |
| Packaging Group | None allocated |
| Hazchem Code | None allocated |
| Special Transport Precautions | None allocated |
15. REGULATORY INFORMATION:
| AICS | All ingredients present on AICS. |
16. OTHER INFORMATION
| Acronyms | ACGIH | American Conference of Government Industrial Hygienists |
| AICS | Australian Inventory of Chemical Substances | |
| CAS | Chemical Abstracts Service Registry Number | |
| COC | Cleveland Open Cup | |
| DG Class | Dangerous Goods Class | |
| EPA | Environment Protection Agency | |
| Hazchem | Codes of numbers and letters which gives information to emergency services | |
|
IP PMCC |
Institute of Petroleum Pensky-Martens Closed Cup |
|
| NOHSC | National Occupational Health and Safety Commission | |
| SUSDP | Standard for the Uniform Scheduling of Drugs and Poisons | |
| UN Number | United Nations Number |
CONTACT POINT
| Contact | Laboratory Manager | |
| IMPORTANT DISCLAIMER | All reasonable care has been taken to ensure that the information and advice contained herein are accurate at the time of printing. However, Oberon Manufacturing Co. accepts no tortuous or contractual liability for any loss or damages suffered as a consequence of reliance on the information and advice contained herein. | |
靖玉貿易行銷有限公司
台灣 桃園市 326-46 楊梅區民族路 5 段 201 巷 124 號
TEL : 03-4206896 FAX : 03-4202206 http:www.jingyu.biz
